Permobil K450 Service Manual page 25

Magnetic brake
8. Unhook the brake release cable spring from
the magnetic brake.
9. Remove the magnetic brake, which is held in
place with three screws. See illustration. There
is also the release control on the left side of
the chassis, held in place with the same
screws.
Fitting
Fit in the reverse order.
Use a torque wrench
screws holding the magnetic brake in place to
2.1 ft-lbs (2.9 Nm).
NOTE
Check the function of the brake release after fitting. When the
brakes are disconnected, it should not be possible to drive
the wheelchair.
to tighten the
25
Unhook the brake release cable spring.
The magnetic brake is held in place
with three screws.
Magnetic brake
Magnetic brake