Disassembly / Reassembly (Ip-422); G Removal / Installation Of Compact Flash - Konica Minolta IP-423 Service Manual

HOME
Chapter 2 Disassembly / Reassembly
I

Disassembly / Reassembly (IP-422)

G
Removal / Installation of Compact Flash
The Compact Flash contains the system software for operating the printer controller. The Compact Flash
needs to be replaced when the printer controller does not boot up at all and the recovery procedure is of no
avail. In replacing the Compact Flash, be sure to use a Compact Flash specifically designed for the printer
controller. The use of any other Compact Flash in not allowed.
1.
Remove 8 screws, and remove the board cover.
2.
Remove Compact Flash.
The width of a
slot is large.
2-2
Caution:
Installation
Assembly should be made in reverse order of disassembly unless other-
wise noted.
Caution:
Installation
The width of the grooves on the left and right of the Compact Flash are dif-
ferent to prevent it being installed incorrectly. Do not force the Compact
Flash into the slot as this may cause damage.
The width of a
slot is narrow.