Konica Minolta IP-423 Service Manual page 11

HOME
2. Installation Requirements
•
Do not place the copier /
such as curtains or volatile materials that may catch fire.
A risk of fire exists.
•
Do not place the copier /
such as rain water.
A risk of fire and electric shock exists.
•
When the copier / print controller units are not used over an extended
period of time (holidays, etc.), switch it off and unplug the power cord.
Dust collected around the power plug and outlet may cause fire.
•
Do not place the copier /
sunlight or near a heat source such as a heater.
A risk of degradation in copier / print controller units performance or
deformation exists.
Do not place the copier /
wind.
Recommended temperature and humidity are as follows:
Temperature: 10°C to 30°C
Humidity: 10% to 80% (no dew condensation)
Avoid other environments as much as possible.
•
Do not place the copier /
much dust, cigarette smoke, or ammonia gas.
Place the copier /
vent machine problems and image faults.
•
The copier generates ozone gas during operation, but it is not sufficient to
be harmful to the human body.
If a bad smell of ozone is present in the following cases, ventilate the
room.
a. When the copier is used in a poorly ventilated room
b. When taking a lot of copies
c. When using multiple copiers at the same time
WARNING: Prohibited Installation Place
print controller units near flammable materials
in a place exposed to water
print controller units
WARNING: Nonoperational Handling
CAUTION: Temperature and Humidity
in a place exposed to direct
print controller units
in a place exposed to cool
print controller units
CAUTION: Ventilation
print controller units in a place where there is
print controller units in a well ventilated place to pre-
SAFETY AND IMPORTANT WARNING ITEMS
S-5