PACOM PDR16-RMT Series User Manual page 62

User's Manual
5. Backup Status displays whether a target bank has already been backed up or not.
6. Select the bank to back up by clicking the target bank in the list box. Multiple banks can be selected by using the
Ctrl or Shift keys on the actual keyboard. Click each bank to be backed up while pressing and holding the Ctrl key.
If you want to select all banks in a specific range, click the first and last banks to be backed up within the range
while pressing and holding the Shift key.
7. Move to Destination, and select a backup drive from a drop-down list.
8. The number of selected banks will be displayed in the Selected Banks box. The Free Backup Banks box
displays the number of banks that are available for backup.
9. Click the Update button to update the record bank information. After you have set up the Manual Backup by List,
click the OK button. Selecting Cancel exits the dialog box without saving the settings.
Setup
Click the Setup... button in the SmartBackup dialog box to set up the backup information. The following Setup
dialog box appears.
1. Move to Auto-backup, and check the box to set up auto backup. If this box is checked, the DVR will back up
automatically according to the established auto backup settings. If Auto-backup is not selected, the DVR is in the
manual backup mode and follows the established manual backup settings. See the Manual Backup section for
setting up the manual backup.
NOTE: During Auto Backup, event recording data of camera channels that are set under pre-event recording
mode will NOT be backed up.
2. Latest Backup Time shows the latest backup date and time. When the DVR is set to Auto Backup mode, only the
banks recorded after Latest Backup Time will be backed up.
3. Move to Period (time), and set the backup beginning time in Start, and ending time in Finish using the arrow
buttons. If you set the value to 0 for the Start and to 24 for the Finish, the DVR will back up from 0:00 to 24:00
automatically with checking out the bank periodically..
4. Move to Backup Drive. If you want to recycle all the backup drive, click the Repeat box. If the Repeat box is
not checked, the DVR stops backing up when all the backup drive is full. Click the Auto Eject box to use the auto
eject feature of the backup drive if the drive is so equipped.
NOTE: Repeat and Auto Eject can not be selected at the same time.
NOTE: Active menus under the Backup Drive will vary depending on the type of media used.
5. Click the Initialize... button to initialize the backup space. The backup drive should be initialized before backing
up.
56