Table of Contents
Advertisement
3
1300 Series EDi Models WK to WS
5 Locate and correct the problem. Always ensure that the engine and starter motor are stationary before the
starter motor is engaged again.
2
2
When the engine starts, check that the lubricating oil pressure exceeds 138 kPa (20 lbs/in
) 1,4 kgf/cm
within
the first 10 seconds, see "Engine data" on page 8 for the correct lubricating oil pressure.
If a gauge is not fitted, check that the warning light for low oil pressure is extinguished. If this does not occur,
stop the engine and find and correct the fault. Allow the engine to warm at approximately 1000 rev/min for three
to five minutes before load is applied.
14
User's Handbook, TPD 1352E, issue 4
Hide quick links:
Advertisement
Table of Contents
