Decals - BraunAbility Entervan II Owner's Service Manual

W ARNING
Replace missing, worn
or illegible decals.
Failure to do so may
result in serious bodily
injury and/or property
damage.
Remember — the Entervan is only as safe as the operator.
Clean "Mist-Grey" powder-coated surfaces (or
painted surfaces) with isopropyl alcohol before
decal application. Use a clean cloth or paper
towels. DO NOT use oily shop rags. Wipe
surface free of residue with dry portion of
cleaning cloth.
Note: Pay close attention to the mask removal
procedure when posting die-cut decals.
Page 52

Decals

The decals posted on your
Entervan are shown by
mounting location. Part
numbers are provided for
all decals. Inspect your
Entervan regularly for any
missing, worn or illegible
decals. Call 1-800-THE
LIFT for replacements.
Decal Application Procedure
To remove the masking, start an edge and peel
back slowly, at a sharp angle directly over the top
of the decal.
Locations:
• Posted on driver's side door (top photo).
• Post on passenger's side door (bottom photo).
Die-Cut Logo Decal Application:
1. Thoroughly clean the area where decal is
2. Carefully remove backing paper from
3. Position decal as shown in photos (align
4. Using a plastic squeegee, firmly press the
5. To remove the masking, start an edge
Courtesy Requested
Actual Size: 3" Wide x 4" Tall
Two Courtesy Requested
Parking Courtesy
Requested decals are supplied with
all Entervans to be posted
TM
"Providing Access to the World"
International Corporate Hdqrs: P.O. Box 310 Winamac, IN 46996 USA
1-800-THE LIFT (219) 946-6153 FAX: (219) 946-4670
Fairfield, NJ USA Clearwater, FL USA Huntington Beach, CA USA
on the vehicle as desired.
Oslo, Norway Kitchener, Ontario Can. Rocklea, Queensland Aust.
12375
Mask Removal
Entervan Logo Decal #51248
Actual Size: 14" x 2-1/2"
to be applied with grease and wax
remover. Dry completely.
decal, making sure all pieces remain
attached to carrier (masking paper).
horizontally with door panel).
decal into place. Be certain all areas
have been squeegeed thoroughly.
and peel back slowly at a sharp angle,
directly over the top of the decal as
shown above.
Decal #12375
TM