Open/Close Switches; Rear Wall-Mounted Manual/Auto And Open/Close Switches - BraunAbility Entervan II Owner's Service Manual

Control Switches (continued)
Dash-Mounted Control Switches
Yellow OPEN/CLOSE Switch
Press the yellow OPEN/CLOSE
switch to the CLOSE (up) posi-
tion to fold (raise) the ramp, close
the automatic door and activate
the "kneel" system*.
Press the yellow OPEN/CLOSE
switch to the OPEN (down)
position to open the automatic
door, unfold (lower) the ramp and
activate the "kneel" system*.
Rear Wall-Mounted Control Switches
Yellow OPEN/CLOSE Switch
Press the yellow OPEN/CLOSE
switch to the CLOSE (up)
position to fold (raise) the ramp,
close the automatic door and
activate the "kneel" system*.
Press the yellow OPEN/CLOSE
switch to the OPEN (down)
position to open the automatic
door, unfold (lower) the ramp and
activate the "kneel" system*.
Page 8
Pre-Operation Notes and Details
See page 11 for overall view of
dash-mounted control switches.
Control Switches
(Detail Photo Below)
* The KNEEL switch turns the
"kneeling" system on and off
only. Pressing the OPEN/
CLOSE switch automatically
activates the "kneeling" feature
to lower the vehicle if the red
dash-mounted KNEEL switch
is in the YES (up) position.
Pressing the CLOSE switch
activates the "kneeling" feature
to raise the vehicle if the red
dash-mounted KNEEL switch
is in the YES (up) position.
Red KNEEL Switch:
Press the red KNEEL switch to
the YES (up) position to turn
the "kneel" system* on.
Press the red KNEEL switch to
the NO (down) position to turn
the "kneel" system* off.
MANUAL/AUTO Override
Switch: This switch must be
pressed to the AUTO position
before automatic (power) ramp
functions can be activated.
Pressing this switch to the
MANUAL position allows the
power ramp to be manually
operated in event of power or
equipment failure. This switch
must be in the MANUAL position
when performing Manual Ramp
Operating Procedures.
OPEN/CLOSE Switch: This
switch is identical to the dash-
mounted OPEN/CLOSE switch in
appearance and operation.
Black MANUAL/AUTO Switch
Press the black MANUAL/AUTO
switch to the MANUAL (up)
position before performing
Manual Ramp Operating Proce-
dures.
Press the black MANUAL/AUTO
switch to the AUTO (down)
position before performing
automatic Power Operating
Procedures.