Power Operating Instructions - BraunAbility Entervan II Owner's Service Manual

Entervan II Power Operating Instructions
The instructions provided below outline the step-by-
step procedures required to operate the automatic
kneel, door and ramp systems. These instructions
also appear on Power Operation instructions decal
#52211 (posted on the interior wall panel above the
power ramp motor assembly).
Review the Pre-Operation Notes and Details
section for detailed information regarding all
Kneeling Delay: The red dash-mounted KNEEL
switch turns the "kneeling" system on and off. The
rear of the vehicle will automatically "kneel" (lower)
when one of the OPEN controls is activated for two
seconds or longer. The OPEN control must be
activated for two seconds or longer before the
"kneel" system lower function is activated. See
pages 11 and 12 for further details.
Note: Engage the vehicle transmission in
"Park," engage the vehicle parking brake and
press the MANUAL/AUTO override switch to
the AUTO position before operation.
FOR POWER KNEELING:
Press the red KNEEL switch to the YES (up)
position. Note: See Kneeling Delay above.
TO OPEN DOOR AND UNFOLD RAMP:
Press the OPEN switch or turn the Passenger
Door Outside Key Entry key clockwise until the
door opens fully and the ramp unfolds fully.
Release switch or key. Note: See Key Entry
Delay above.
Note: After the door is fully open, a minimum
two second delay will occur before the ramp
starts to unfold. Note: See Ramp Delay above.
Page 18
W ARNING
Be aware of
ramp slope.
52217
Entervan control
switches, functions and
operating procedures.
Manual Instructions:
Refer to the Manual
Operating Instructions
on pages 21-24 if you experience power or equip-
ment failure.
Ramp Delay: After the door is fully open, a mini-
mum two second delay will occur before the ramp
starts to unfold. See Passive (Non-Wheelchair)
Access on the following page for further details.
Key Entry Delay: When activating OPEN functions
using the outside key entry, the key unlocks the
door and then there is a two second delay before
the Entervan power functions are activated.
TO FOLD RAMP AND CLOSE DOOR:
Press the CLOSE switch or turn the Outside Key
Entry key counterclockwise until the ramp folds
fully and the door closes fully.
Note: You must continue to press the CLOSE
switch or turn the Outside Key Entry key counter-
clockwise through the entire ramp folding and
door closing functions.
TO TURN POWER KNEELING OFF:
Press the red KNEEL switch to the NO (down)
position.
W ARNING
Read and become
familiar with all safety
precautions, pre-
operation notes and
details, operating
instructions and
manual operating
instructions before
operation. Failure to
do so may result in
serious bodily injury
and/or property
damage.