Troubleshooting Diagnosis Chart - BraunAbility Entervan II Owner's Service Manual

FUNCTION SYMPTOM
continued continued
10.30
No
10.00
CLOSE
KEY ENTRY
Operation
10.40
Faulty CLOSE
Operation
11.10
No
Release
Operation
11.20
Faulty
Release
Operation
11.00
Passive
11.30
Access
Faulty
System
Rotation
Operation
11.40
No Latching
Operation
11.50
Faulty
Latching
Page 42

Troubleshooting Diagnosis Chart

POSSIBLE CAUSE
10.31 See 1.00
10.32 Key Entry Close microswitch
harness disconnected or
defective
10.33 Key Entry Close microswitch out
of adjustment or defective
10.41 See 10.21 and 10.33
11.11 Release cable broken, discon-
nected or otherwise defective
11.12 Faulty Passive Access latch (will
not disengage)
11.21 Loose, worn or otherwise
damaged Passive Access latch
11.22 Missing, loose, worn, bent,
misaligned or otherwise
damaged Passive Access latch
pin (bolt assembly)
11.23 Mechanical binding
11.24 Lack of lubrication to latch
11.31 Missing PVC washer at bottom
pivot point (axle)
11.32 Misalignment, deformation, wear
or other damage to top and/or
bottom pivot points (axles and/or
bearing surfaces)
11.33 Misalignment, deformation,
looseness, wear or other
damage to inboard (floor) ramp
hinge assembly, floor and lower
slide door track assembly or
mounting hardware
11.34 Mechanical binding
11.35 Lack of lubrication to top and
bottom pivot points
11.41 Faulty Passive Access latch (will
not engage)
11.42 See 11.20
11.51 Release knob does not seat
properly in knob retainer bracket
preventing latch from returning
to spring-loaded latch position
11.52 See 11.20, 11.33 and 11.41
REMEDY
Connect, repair or replace
Adjust or replace
Connect or replace cable
Replace latch
Tighten, replace or otherwise correct as
needed
Tighten, replace or otherwise correct as
needed
Correct as needed
Lubricate with * Light Oil
Replace washer
Correct as needed
Correct as needed
Correct as needed
Lubricate with * Light Oil
Replace latch
Cable Adjustment: Loosen cable
securement Allen screws at knob and
insert cable further and resecure.
Remove knob and shorten cable (1/8"
intervals) if needed only.