3. Disengage the solenoid bracket from the plunger.
Note: When a new solenoid assembly is installed, the fuser sole-
noid must be adjusted.
Fuser Thermistor Removal
1. Disconnect the thermistor cable connector [A] from the exit
sensor card.
2. Remove the fuser cover and wiper.
3. Remove the tape holding the thermistor cable to the shroud.
4. Squeeze the thermistor bracket tabs [B] and remove the
thermistor from the shroud.
5. Remove the thermistor cable from the guide clips on the right of
the fuser to remove the thermistor.
72
Service Manual