IBM 3112 Service Manual page 26

Error Code
972 Network Card 2
973 Network Card 1
973 Network Card 2
974 Network Card 1
974 Network Card 2
976 Network Card 1
976 Network Card 2
977 Network Card 1
977 Network Card 2
978 Network Card 1
978 Network Card 2
979 Network Card 1
10
Service Manual
Explanation
Network card 2 ROS/FLASH failure.
Replace network card 2.
Go to "Host Printing Problems" on
page 22.
Network card 2 EEPROM/NVRAM
failure. Replace network card 2.
Go to "Host Printing Problems" on
page 22.
Network card 2/Network interface error.
Replace network card 2.
Host card 1 software error. Verify that the
network card is installed and grounded
correctly. If this error returns after a POR,
there is a software or microcode
incompatibility problem. Do not replace
the card. Contact your next level of
support.
Network card 2 software error. Verify that
the network card is installed and
grounded correctly. If this error returns
after a POR, there is a software or
microcode incompatibility problem. Do
not replace the card. Contact your next
level of support.
Host card 1 is installed but is not
communicating with the RIP Board. See
"Network Card 977 Errors" on page 25.
Network card 2 is installed but is not
communicating with the RIP Board. See
"Network Card 977 Errors" on page 25.
General host 1 card hardware error. Go
to "Host Printing Problems" on page 22.
General network 2 card hardware error.
Replace network card 2.
General host 1 card software error. Verify
that the network card is installed and
grounded correctly. If this error returns
after a POR, there is a software or
microcode incompatibility problem. Do
Not replace the card. Contact your next
level of support.