Table of Contents
Advertisement
Error Code
64 Defective Disk
7X Network Card Codes
For example, 71:X
80 Scheduled Maintenance
88 Toner Low
90X Software Error
917 Transfer Roll Error
Explanation
The printer will ignore a disk it senses as
defective. Run the Quick Disk Test. If the
test fails, the disk is defective or the data
on track 1 is bad. If the Quick Disk Test
passes but the disk does not work, run
the Disk Test/Clean (2 hour test).
Replace the disk if instructed by the
operator panel.
These user codes are documented in the
Network Printer Utility Guide (SA40-
0822). See "Network Wrap Tests" on
page 25. Note: 7X codes are normal
when an INA is installed but no LAN
cable is attached. Press "Disable" to
continue.
Printer has reached 200,000 prints
without maintenance count reset.
Toner sensor detects low toner.
Unrecoverable software error. If one of
these errors appeared during POST, or
while the printer was idle (not printing or
receiving data), or while trying to print
one of the internal test pages, replace the
RIP Board. If the error appeared while
sending a job from the host to the printer,
turn the printer off, then turn it on and try
again. If the error appears again, call the
next level service support for assistance.
Cannot start servo operation. Verify
correct cable connections from the
engine board to the HVPS. Make sure
there is continuity between the transfer
roller and its contact on the HVPS;
replace the transfer roll if the continuity is
correct. If there is no continuity, make
sure the HVPS contact returns to its
upward limit when depressed, and make
sure the left bearing of the transfer roll is
making proper contact.
Diagnostic Information
7
Advertisement
Table of Contents
