Listening To External Equipment - JVC UX-J99DVD Instructions Manual

Listening to External Equipment

Listening to External Equipment
You can listen to external equipment connected to the AUX jacks
and OPTICAL DIGITAL IN terminal on the rear of the unit.
• First make sure that the external equipment is properly connected
as follows (see also "Connecting Other Equipment" on page 9):
DO NOT connect other equipment while the
power is on.
To OPTICAL DIGITAL
IN terminal
AUDIO
OPTICAL
PCM
DIGITAL
IN
DVD OPTICAL
PCM/
STREAM DIGITAL
To audio output
OUT
LEFT
RIGHT
To AUX jacks
1
On the remote control:
Press FM/AM/AUX repeatedly until
"AUX" (for AUX jacks) or "AUX-
DIGITAL" (for OPTICAL DIGITAL IN
terminal) appears on the display.
• Each time you press the button, the source changes as follows:
FM
AUX-DIGITAL
On the unit:
Press AUX.
• Each time you press the button, the source
alternates between "AUX" and "AUX-DIGITAL"
on the display.
2
Turn down the volume level to "VOLUME MIN."
(On the remote control)
3
Start playing the external equipment.
• For operation of the external equipment, refer to the manuals
supplied with it.
To digital audio
output
External equipment
AM
AUX
AUX
FM/AM
VOLUME
+
–
(On the unit)
4
Adjust the volume level to your desired listening
level.
5
Apply sound effects, if you wish.
• For how to apply sound effects, see pages 11 and 12.
To adjust the Audio Input Level
If the sound from the component connected to the AUX jacks is too
loud or is not loud enough when changing from another source to
"AUX," you can change the audio input level through the AUX jacks
(without changing the volume level).
On the remote control ONLY:
Press and hold SET for more than 2 seconds
while the source is "AUX."
• Each time you press and hold the button, the audio input level
alternates between "LEVEL 1" and "LEVEL 2."
LEVEL 1: Select this when the sound is too loud (initial
setting).
LEVEL 2: Select this when the sound is not loud enough.
To change the information shown on the display
On the remote control ONLY:
Press DISP/CHARA.
Each time you press the button, the information on the
display alternates between the source indication and
the clock indication.
44