HiPer II Receiver Setup
After receiver survey configuration, set up each receiver, measure its
height, and begin surveying. The LED Display Panel provides quick
access for: logging data and viewing general data logging and
satellite information during a survey.
Receiver Setup
A typical GPS survey system consists of a Base station set up over a
known point and a Rover receiver set up as a mobile data collector.
After setting up the Base and Rover receivers, the antenna height
must be measured.
Before collecting data, make sure the Base and Rover receivers
contain a current almanac and current ephemeris data (see "Collecting
Almanacs and Ephemerides" on page 2-7).
Step 1: Set up the Receivers
The Base station must be set up, logging data, and transmitting data
before setting up the Rover receiver. Receiver setup for either post-
processing or RTK surveys is the same.
Set up the Base station and its components.
See "To set up the Base receiver" on page 4-1 for details.
Set up the Rover receiver.
See "To set up the Rover receiver" on page 4-3 for details.
To set up the Base receiver
1. Install a tripod over a known control point.
2. Secure the universal tribrach onto the tripod. Place the tribrach
adapter onto the tribrach and tighten the screws.
P/N 7010-0982
(Figure 4-1):
Chapter 4
4-1