Data And Power Ports - Topcon HiPer II Operator's Manual

Introduction
The following events generate messages from the HiPer II audible
annunciator:
AUDIO EVENT INDEX
N EVENT NAME
1
LOGEPOCH
2
STARTUP
3
SHUTDOWN
4
BTNPOWER
5
BTNFRESET
6
BTNFORMAT
7
BTNIGNORE
8
BATTLOW
9
MEMLOW
10
MEMFULL
11
RTKFIXED
12
RTKFIXLOST
13
CONNECT
14
DISCONNECT

Data and Power Ports

The HiPer II has the two ports described below (Figure 1-10 on
page 1-23):
• Serial - rimmed in black; used for communication between
the receiver and an external device. The body of the
connector on the corresponding cable is black.
• Power - rimmed in red; used to connect the receiver to an
external power source. The body of the connector on the
corresponding cable is red.
1-22
DESCRIPTION
Message recorded to file
System has completed startup
Receiver is shutting down (immediate)
Power Button – Power Off
Power Button – Factory Reset
Power Button – SD Format
Power Button – Return to normal operation
Battery power is low
Remaining space on SD memory card is low
SD memory card is full
RTK solution is now Fixed
RTK solution is no longer Fixed
Bluetooth has been connected
Bluetooth has been disconnected
HiPer II Operator's Manual