Turning On/Off the Receiver
To turn ON the receiver, press and hold the power button
until the LEDs briefly flash.
To turn OFF the receiver, press and hold the power button
for more than one and less than four seconds (until both the
STAT and the REC LEDs are off).
Installing the SDHC Card
The SDHC card provides memory space in which to save
logged data. Although you may install an SDHC card of any
size, the receiver will recognize only up to 2 GB of memory.
Always initialize the file system on the installed SDHC card
before the first use. Initialization procedure is described in
"Initializing File System" on page
1.
Ensure the receiver is turned off.
2.
Remove the battery to the left of the MINTER.
3.
Carefully insert the SDHC card, label side down, into
the SDHC card slot located at the top of the battery
compartment.
P/N 7010-1022
Turning On/Off the Receiver
51.
www.topconpositioning.com
23