Data And Power Ports - Topcon Net-G3 Operator's Manual

Introduction

Data and Power Ports

The Net-G3A has ports on both the front and back panels.
The front panel
SNAP) – used for communication between the receiver and an
external device. This is the receiver's serial port A.
The back panel
page 1-16):
• Serial ports (9 pin D-shell connector) – used for communication
between the receiver and an external device.
1-14
has one port (Figure 1-3): Serial (7 pin ODU-MINI-
Serial Port
STAT LINK
REC RX/TX
Figure 1-3. Net-G3A Front Panel Ports
has the following 10 ports (Figure 1-5 on
PWR 1
FN
PWR 2
NET-G3A Operator's Manual