Table of Contents
Advertisement
INSTALLING THE LNB/WAVEGUIDE
PARTS NEEDED
•
LNB/Waveguide assembly
• M4 Allen screws, Qty: 4
• M4 Lock washers, Qty: 4
1. Facing the front of the feed arm, locate the red mark on the
right side of the rectangular section with four holes (see
Figure 31).
2. Install the O-ring in the circular depression in the feed arm
(see Figure 32.) Note that the circular depression contains
four small depressions at 12, 3, 6, and 9 o'clock. These are
pinch points. Be sure to push the O-ring in at these points to
achieve a better seal.
3. Orient the LNB/waveguide so that the flat side of the LNB
faces your body, and the red mark is on the right (see
Figure 33).
4. Line up the feed arm rectangular section with the waveguide
so that the four screw holes align. The two red marks should
be on the same side but may or may not align exactly. Use
the red marks as guides. What is important is that the four
screw holes align (see Figure 34).
5. Install the M4 Allen screws and lock washers with the Allen
wrench that is provided.
Red mark
Figure 31
• Feed arm
• O-ring
TOOLS NEEDED
• Allen wrench (supplied)
Figure 32
Waveguide
Red Mark
LNB
Figure 33
Figure 34
25
Advertisement
Table of Contents
