Table of Contents
Advertisement
SATELLITE DISH KIT COMPONENTS
YOUR SATELLITE DISH KIT SHOULD INCLUDE THE FOLLOWING ITEMS:
Satellite Dish (rear view)
Azimuth/Elevation Cap
PARTS LIST
Your kit also contains assorted hardware. Depending on how you install and ground your system, you may have some
hardware left over when you are done. You will have to supply other items. Go to page 4 to view a table that lists what you will
need to supply.
• M4 Allen screws, Qty: 4
• Red O-ring, Qty: 1
• Galvanized washers, 3/8-inch Qty: 6
• Allen wrench, 3mm, Qty: 1
• Lag screws, 1/4-inch x 4-inch, Qty: 4
• Lag screws, 3/8-inch x 2-inch, Qty: 4
• Lag screws, 3/8-inch x 4-inch, Qty: 6
• 5/16-inch Nylock nuts, Qty: 4
Mast and Base
Plate
Shroud
Brace kit
• 5/16-inch Lock washer, Qty: 1
• 1/4-20 Hex-Head Nut, Qty: 1
• 5/16-18 x 2-inch Hex screw, Qty: 1
• 5/16-18 Wedge nut, Qty: 1
• 5/16-inch Flat washer, Qty: 5
• Galvanized washers, 1/4-inch, Qty: 4
• 1/4-20 x 1/2-inch Hex-Head Bolt, Qty: 1
• 1/4-inch Lock washer (star washer for
grounding), Qty: 1
Feed Arm
LNB/Waveguide Assembly
Also included are the indoor
items that are necessary to
connect the satellite dish
and your computer. See the
installation guide that comes
with the software and indoor
components (packaged sep-
arately in the antenna box)
for a complete list.
1
Advertisement
Table of Contents
