Hughes DW 3000 One-Way Installation Manual page 23

INSTALLING THE MOUNT ON A WOOD FRAMED ROOF
9. Detach the strut from the mounting plate and repeat step 5
through step 9 for the lower center hole. Reattach the strut
when done.
10. Secure the collar to the mast by using a 7/16-inch socket
wrench to tighten the Nylock nut installed on the bolt.
11. Re-plumb the mast.
12. Slip the long 25-inch strut collar over the mast until it fits as
shown in Figure 19.
13. Position the strut so that its mounting plate center holes are
on center of the rafter immediately to the left (or to the right
if you prefer). The 25-inch strut should be at approximately
a 90° angle to the 18-inch strut. At the same time, minimize
any angle formed between the 25-inch strut and the center-
line of the mast base plate (see Figure 19).
14. Repeat step 4 through step 10 for the 25-inch strut mounting
plate.
15. Re-plumb the mast. If you had to loosen the adjustment nuts
to plumb the mast, snug them again to 18 ft.-lbs.
Note: The mast must be plumb before you can proceed. If you cannot
plumb the mast, repeat the steps above or find another installation
site.
Continue with section "Installing the Cap Onto the Satellite
Dish" on page 23.
Figure 19
19