Led Indicator Panel - Riello Dialog Plus DLP series User Manual

I
NSTALLATION AND
L
ED INDICATOR PANEL
This chapter gives a detailed description of all LED indicator panel.
ICON
0MNUOC1RUA_GB (614-06498-00)
U
SE
STATUS
Red / Steady
Red /
Flashing
Green / Steady
Green / Flashing
Green / Steady
When operating off battery power, the UPS signals that it is about to
Green / Flashing switch off due to end of discharge. In this state, it beeps at regular
Red / Steady
Yellow / Steady
Represents the estimated percentage of battery charge by 5 LEDs
Green / Active
Hold the ON button down for at least 10 seconds to show the input
Green – Red / Indicates the % of load applied to the UPS in relation to the nominal
Active
Tab. 1
Battery status
Normal
Low
●
LED with steady light on
♦
LED with flashing light on (1 flash per second)
DESCRIPTION
Indicates an fault
The UPS is in stand-by mode
The UPS is operating on mains power
The UPS is operating off the bypass
The voltage input is out of the accepted range
The UPS is operating in battery mode and will beep at regular
intervals of 1 sec. (see Tab. 1)
Indicates battery failure
The loads connected to the UPS are powered by the bypass
(see table 2)
voltage value (see table 3)
value. the last icon indicates overload (see table 4)
LED - battery working -
●
♦
intervals.