York Fitness G-570 Instruction Manual page 33

INSTRUCTION
You will need assistance to pass the narrow end of
the BENCH PRESS ARM (40) either side of
the SIDE WEIGHT COVERS (108) from the
front and align with pivot tube mounted on
the REAR MAIN UPRIGHT (30).
NOTE: Ensure bracket in centre is on the left
side as illustrated.
Insert the PIVOT ROD (127) through one side of
the BENCH PRESS ARM (40), through
the pivot tube mounted on the REAR MAIN UPRIGHT (30)
and out flush with the other side of the BENCH PRESS ARM (40),
then secure using the bolts, washers and plastic caps as illustrated.
Attach the top hole of the UPPER HEIGHT ADJUSTER (25)
to the bracket on the cross bar of the BENCH PRESS ARM (40)
using the nut, bolt and washers as illustrated.
58
M10 X 50mm HEX HEAD BOLT X
60
M10 X 25mm HEX HEAD BOLT X
70
10.5mm X 23mm X 2mm
2
FLAT WASHER X
68
M10 NYLON
1
LOCKNUT X
SHOULD YOU REQUIRE ANY ASSISTANCE REGARDING THIS PRODUCT PLEASE CONTACT YORK DIRECTLY
71
25
10.5mm X 40mm X 3mm
1
101
60
2
68
70
2
FLAT WASHER X
NOTE: Remove PIVOT ROD
71
BENCH
PRESS
40
ARM
70
58
101
17 X 17 X 44mm
PLASTIC END CAP X
from REAR MAIN
UPRIGHT before fitting
BENCH PRESS
ARM, then refit.
71
60
127
YORK G570 / 31
2
101