York Fitness G-570 Instruction Manual page 22

INSTRUCTION
Insert ball end of HIGH/LOW PULLEY CABLE (118) end
pointing upwards) into ROTATING PULLEY BRACKET (36)
and mount PULLEY WHEEL (113) in front using the bolt, washers,
nut and plastic caps as illustrated.
Feed other end of HIGH/LOW PULLEY CABLE (118)
through front of slot in bottom of HIGH/LOW SUPPORT TUBE (33)
and fix PULLEY WHEEL (84) with PULLEY COVERS (85)
above cable using nut, washers, bolt and spacers as illustrated.
Attach 4 x PULLEY WHEELS (84) to
HIGH/LOW CROSS SUPPORT (35)
using bolts, washers, nuts and plastic caps as illustrated.
Feed HIGH/LOW PULLEY CABLE (118) up rear
and from outside pass over rear PULLEY WHEEL (84) at top of
HIGH/LOW SUPPORT TUBE (33), over the second
rear PULLEY WHEEL (84) before passing under
HIGH/LOW SUPPORT TUBE (33).
Loop HIGH/LOW PULLEY CABLE (118) back up
over the near side front PULLEY WHEEL (84) followed
by the outside PULLEY WHEEL (84), then down and mount
the cable end inside the small bracket at top of
PULLEY GLIDE BRACKET (34) using bolt,
washers and nut as illustrated.
Now mount PULLEY WHEEL (84) with
2 x PULLEY COVERS (85) above the loop of
cable under HIGH/LOW CROSS SUPPORT (35)
and pass one end of SINGLE PULLEY BRACKET (39)
either side from under HIGH/LOW PULLEY CABLE (118)
and attach using nut, bolt and washers as illustrated.
47
M10 X 125mm HEX HEAD BOLT X
58
M10 X 50mm HEX HEAD BOLT X
57
M10 X 65mm HEX HEAD BOLT X
61
M8 X 37mm HEX HEAD BOLT X
SHOULD YOU REQUIRE ANY ASSISTANCE REGARDING THIS PRODUCT PLEASE CONTACT YORK DIRECTLY
YORK G570 / 20
18
2
2
1
1
101
17 X 17 X 44mm
PLASTIC END CAP X
103
PLASTIC END CAP X
73
8.5mm X 20mm X 2mm
2
WASHER X
70
10.5mm X 23mm X 2mm
8
FLAT WASHER X
72
mm
10.5 X 23mm X 2mm
2
CURVE WASHER X
4
17mm X 17mm
2
66
M8 NYLON
1
LOCKNUT X
68
M10 NYLON
5
LOCKNUT X
112
PULLEY WHEEL
2
SPACER X