York Fitness G-570 Instruction Manual page 28

21
INSTRUCTION
Screw bolt end of CONNECT CABLE (124) into bottom of SINGLE PULLEY BRACKET (39)
and feed other end from outside through slot in side of FRONT CROSS SUPPORT (2)
fixing PULLEY WHEEL (84) and PULLEY COVERS (85) above CONNECT CABLE (124)
using nut, bolt and washers as illustrated.
Fit another PULLEY WHEEL (84) with PULLEY COVERS (85) to bottom
of PULLEY BRACKET PLATE (38) while first looping CONNECT CABLE (124)
over top from rear to front and secure using bolt, washers and nut as illustrated.
Attach PULLEY WHEEL (84) with PULLEY COVERS (85) to the end
hole of DOUBLE PULLEY BRACKET (29) and secure using nut,
washers and bolt as illustrated while first looping CONNECT CABLE (124) under wheel from rear to front.
Now fit another PULLEY WHEEL (84) with PULLEY COVERS (85) to bottom of
ANGLED DOUBLE PULLEY BRACKET (37) while first looping CONNECT CABLE (124)
over top from front to rear and secure using bolt, washers and nut as illustrated.
Feed CONNECT CABLE (124) down the left side of the gym and loop from rear under PULLEY WHEEL (84)
mounted on the outside of FRONT CROSS SUPPORT (2).
Attach another PULLEY WHEEL (84) with PULLEY COVERS (85) to the far side of
the PRESS PULLEY BRACKET (22) using the bolt, washers and nut as illustrated then feed cable over top.
st
Insert another PULLEY WHEEL (84) with PULLEY COVERS (85) into 1 empty slot in
FRONT CROSS SUPPORT (2) and in front of LEG EXTENSION CABLE (117), then after fitting
the end hook of CONNECT CABLE (124) onto bolt, secure PULLEY WHEEL (84) in place using bolt, washers,
spacers and nut as illustrated.
Now mount PULLEY WHEEL (84) with 2 x PULLEY COVERS (85) under the loop
of CONNECT CABLE (124) from top of FRONT CROSS SUPPORT (2) and attach to bottom hole
of DOUBLE PULLEY BRACKET (29) using nut, bolt and washers as illustrated.
124
1
CONNECT CABLE 5000mm LONG X
48
112
1
M10 X 100mm HEX HEAD BOLT X
53
PULLEY WHEEL
5
SPACER X
1
M10 X 80mm HEX HEAD BOLT X
57
70
68
1
M10 X 65mm HEX HEAD BOLT X
58
10.5mm X 23mm X 2mm
M10 NYLON
15
FLAT WASHER X
7
LOCKNUT X
4
M10 X 50mm HEX HEAD BOLT X
SHOULD YOU REQUIRE ANY ASSISTANCE REGARDING THIS PRODUCT PLEASE CONTACT YORK DIRECTLY
YORK G570 / 26