York Fitness G-570 Instruction Manual page 24

INSTRUCTION
You will need assistance to locate the single hole end
of LEG EXTENSION ASSEMBLY (31) inside
front bracket of FRONT LEG (16) and align the top
hole of the LEG CURL ASSEMBLY (32) to the
outside of the FRONT LEG (16) bracket, securing both
parts in place using the nut, bolt, washers and plastic caps
as illustrated.
NOTE: Ensure the small bracket at the bottom of
the LEG EXTENSION ASSEMBLY (31)
is facing towards the rear, and the bar of the LEG
CURL ASSEMBLY (32) is facing towards the front.
Slot FOAM ROLLERS (100) onto either end of bar at bottom
of LEG CURL ASSEMBLY (32).
Secure the LEG CURL ASSEMBLY (32) in position by
fitting PULL PIN (80) through centre hole on side through
LEG EXTENSION ASSEMBLY (31) and out the other side.
44
M12 X 80mm HEX HEAD BOLT X
102
100
FOAM
ROLLER
32
LEG CURL
ASSEMBLY
SHOULD YOU REQUIRE ANY ASSISTANCE REGARDING THIS PRODUCT PLEASE CONTACT YORK DIRECTLY
YORK G570 / 22
19
1
LEG EXTENSION
ASSEMBLY
31
67
69
100
FOAM ROLLER
67
LOCKNUT X
69
80
102
19mm X 19mm X 44mm
PLASTIC END CAP X
69
M12 NYLON
M12 X 25mm X 2mm
1
FLAT WASHER X
44
102
2
2