Computer/Printer Setup; Connecting Nanopure To Computer And Communicating Through The Rs-232 Port Using Hyperterminal Or Procomm - Thermo Scientific Barnstead Nanopure TOC - UV Operation Manual

Computer/Printer Setup

Note
Due to character set differences,
hyperterminal may display the
bol as ê. Also, the ° symbol may be
displayed as ø.
38
Connecting Nanopure to
Computer and Communicating
Through the RS-232 Port Using
Hyperterminal or Procomm
Hyperterminal
RS-232 Capture Instructions
1. Connect the 9 pin serial cable (part no. WHX18)
from the Nanopure RS-232 port to COM2: port
or (COM1: port) on back of computer.
2. From the (Idle) display, press the UP or DOWN
arrow until display reads, "Advanced Menu."
sym-
3. Press ENTER.
4. From the "Printer Attached" display, press the
Up or DOWN arrow for (NO).
5. Press ENTER.
6. Now, during the normal Recirculation mode,
date, time, purity and temperature readings will
be sent to the computer once per minute. If
"Use TOC Analyzer" has been set to "Yes," the
TOC data will also be sent.
7. Run your Microsoft Windows program. Open
Hyperterminal (located in the accessories direc-
tory), give your setting a name and choose a
symbol.
8. In the "Connect Using:" box, select "direct to"
COM2: or (COM1: ) as port (depending on your
computer), and click OK.
9. Using the selection boxes in the next screen,
configure the options as 9600 baud, 8-bit, No
parity, 1 stop bit, Flow Control: None.
10. To receive data to a file, select Transfer and
capture text. Accepting default will put the file
which you name in the c:/windows directory