Certifications And Standards - Pro-face GP4104G1D Hardware Manual

Certifications and Standards

Introduction
Pro-face submitted this product for independent testing and qualification by third-
party listing agencies. These agencies have certified this product as meeting the
following standards.
Agency Certifications
The GP unit is certified by the Underwriters Laboratory according to:
Hazardous Substances
The GP unit is designed for compliance with:
CE Markings
This product conforms to the necessary requirements of the following Directives for
applying the CE label:
This conformity is based on compliance with EN61000-6-4, EN61000-6-2 (DC
model, AC model)
This conformity is based on compliance with EN60950-1 (AC model)
UL 508 and CSA C22.2 n°142 for Industrial Control Equipment
WEEE, Directive 2002/96/EC
RoHS, Directive 2002/95/EC
RoHS China, Standard SJ/T 11363-2006
2006/95/EC Low Voltage Directive
2004/108/EC EMC Directive
RISK OF EXPLOSION IN HAZARDOUS LOCATIONS
Verify that the power, input and output (I/O) wiring are in accordance with Class
I, Division 2 wiring methods.
Do not substitute components that may impair compliance to Class I, Division 2.
Do not connect or disconnect equipment unless power has been switched off or
the area is known to be non-hazardous.
Securely lock externally connected units and each interface before turning on
the power supply.
Do not use, connect, or disconnect USB (mini-B) cable connections in
hazardous locations. USB (mini-B) interface is for temporary connection only
during maintenance and setup.
Failure to follow these instructions can result in death, serious injury, or
equipment damage.
GP4000 Series Hardware Manual
WARNING
13