Basic Operation; Turning Power On; Channel Selection - Icom IC-F51V Instruction Manual

3

■ Turning power ON

q Rotate [VOL] to turn power ON.
• When the openng vbraton functon s turned ON, the transcever
vbrates for 2 sec. Ask your dealer for detals.
w If the transcever s programmed for a start up passcode, nput
dgt codes as drected by your dealer.
• The keys n the table below can be used for password nput:
• The transcever detects numbers n the same block as dentcal.
Therefore "01234" and "56789" are the same.
KEY
NUMBER
e When the "PASSWORD" ndcaton does not clear after nput-
tng 4 dgts, the nput code number may be ncorrect. Turn the
power off and start over n ths case.

■ Channel selection

Several types of channel selectons are avalable. Methods may
dffer accordng to your system set up.
NON-ZONE TYPE:
Push [CH Up]/[CH Down] to select the desred operatng channel
n sequence; or, push one of [MR-CH 1] to [MR-CH 4] to select a
channel drectly.
ZONE TYPE:
Push [Zone] then push [CH Up]/[CH Down] to select the desred zone.
AUTOMATIC SCAN TYPE:
Channel settng s not necessary for ths type. When turnng the
power ON, the transcever automatcally starts scannng. Scannng
stops when recevng a call.
14

BASIC OPERATION

0 1
5 6
or
2 3
7 8
4
9