Teeter Hang Ups EP-550 Assembly Instructions Manual page 14

FIGURE 10
FIGURE 11
FIGURE 12
A B C
1 Bracket Pin
STEP 4 Roller Hinge Assembly
FIGURE 9
Unlocked
Pivot Pin
• Familiarize yourself with the Roller Hinge and Cam Lock terms detailed above in Figure 9.
• For ease of assembly, rest the Table Bed against the Crossbar (Figure 10) at the front of the
A-Frame.
• On one side of the Table Bed, lift the Cam Lock up all the way to unlock (Figure 11).
• In your other hand, hold one 3-Hole Roller Hinge at the Pivot Pin. With the Pivot Pin facing out
(away from the Table Bed), slide the bottom of the Roller Hinge between the Cam Lock and
Bracket.
TIP: Make sure that the Cam Lock is completely open when inserting the Roller Hinge, otherwise
assembly will be more difficult.
• Engage one of the holes in the Roller Hinge over the Bracket Pin. Figure 12 shows the Roller
Hinge installed correctly, with the Bracket Pin engaged in Setting C.
NOTE: Refer to the Owner's Manual for an explanation of the hole settings. If you are unsure, use
Setting C to start.
1
• Push down on the Cam Lock to lock it and secure the Roller Hinge.
• Repeat on other side. Make sure the Roller Hinges are in the same hole setting on both sides.
Locked
Bracket Pin
Cam Lock
Bracket
13
WARNING
!
NEVER disassemble the
Roller Hinge Pivot Pin.
the