Teeter Hang Ups EP-550 Assembly Instructions Manual page 16

Based on your model, the item(s) used for this step will differ but the assembly process remains the same.
FIGURE 17
FIGURE 18
FIGURE 19
FIGURE 20
STEP 6 Assemble the Main Shaft
• Loosen the De-Rattler Knob on the left side of the Main Shaft Housing.
• Facing the front of the A-Frame, hold the Main Shaft in your left hand with the height
markings facing up. Slide the end of the Main Shaft into the Main Shaft Housing (Figure
17), located at the base of the Table Bed.
• With your right hand, pull out the Height-Selector Locking Pin (Figure 18) to allow the Main
Shaft to slide in further and release in the desired height setting. Refer to the Owner's
Manual for more information on selecting your height setting.
• The Main Shaft MUST REST against the Crossbar of the A-Frame (Figure 19).
IMPORTANT: The Crossbar prevents the Table Bed from rotating forward when the user
steps on the Ankle Comfort Dial. If the Main Shaft does not rest on the Crossbar as shown
in Figure 19, then the Table Bed has been assembled backwards onto the A-Frame.
This MUST BE CORRECTED before use.
• Test the inversion table by hand for smooth and steady rotation (Figure 20) and ensure that
all fasteners are secure.
• Tighten the De-Rattler Knob.
For users with the EP-550 Sport model, follow the Conversion Bar
Assembly & User Instructions enclosed in this packet.
15