Teeter Hang Ups EP-550 Assembly Instructions Manual page 11

STEP 2
Based on your model, the assembly in this step will differ.
FIGURE 4
FIGURE 4A
FIGURE 5
Over-EZ™ Handle Assembly (EP-850 Models)
For users with the EP-850 Model, assemble the Over-EZ™ Handles:
• Locate the Over-EZ™ Handle Assembly Hardware Kit (HK1023 for EP-850 Models).
• Look for the "R" embossed on the inside of the handle to determine right from left. Select
the right handle.
• Insert the Double-Threaded Bolts from the inside of the handle and loosely hand-tighten on
the outside with the nuts provided (Figure 4). DO NOT fully tighten the nuts yet.
• Align and insert the opposite end of the Double-Threaded Bolts into the corresponding
holes in the right hinge plate (Figure 4A). Hand-tighten with the nuts on the inside of the
hinge plate.
• Use the wrenches provided to tighten the inside and outside sets of nuts, being careful not
to over-tighten. (Figure 5 shows the completed assembly)
• Repeat the entire process with the left handle.
10