Diamondback APEX Ic8 Owner's Manual page 12

ASSEMBLY INSTRUCTIONS
• Remove the four console fi xing screws (A-1) from the back of
the Console (A) and set them aside.
• Plug the upper wire harness connector (B-8) and the Heart
Rate Console Wire (B-7) into the matching connectors on the
back of the Console (A). Make sure both connec ons are fi rmly
connected and click into posi on.
• Posi on the console above the moun ng plate located on
the Handlebar Mast (B). Be careful feeding excess wires into
the opening on the Handlebar Mast (B) while posi oning the
console.
• Reinstall the four (4) fi xing screws (A-1) through the underside
of the plate and into the console. Tighten the four screws only
a er all four have been started by hand.
10