Installing The Chassis Into A Telco Rack - Bosch BRS Tower Hardware Installation Manual

Bosch Recording Station Appliance
1.
2.
3.
4.
4.3.5

Installing the Chassis into a Telco rack

To install the chassis into a Telco type rack, use two L-shaped brackets on either side of the
chassis (four total). First, determine how far follow the chassis will extend out the front of the
rack. Larger chassis should be positioned to balance the weight between front and back. Then
attach the two front brackets to each side of the chassis, then the two rear brackets
positioned with just enough space to accommodate the width of the telco rack. Finish by
sliding the chassis into the rack and tightening the brackets to the rack.
Bosch Security Systems
Confirm that chassis includes the inner rails (A) and rail extensions (B). Also, confirm
that the outer rails (C) are installed on the rack.
Line chassis rails (A and B) with the front of the rack rails (C).
Slide the chassis rails into the rack rails, keeping the pressure even on both sides (you
may have to depress the locking tabs when inserting). When the system has been
pushed completely into the rack, you should hear the locking tabs "click" into the locked
position.
(Optional) Insert and tighten the thumbscrews that hold the front of the chassis to the
rack.
Hardware Installation Manual
Rack Installation | en 37
- | V1 | 2011.10