16
en | Chassis setup
4
Chassis setup
This chapter covers the steps required to install components
and perform maintenance on the chassis.
Caution!
Review the warnings and precautions listed in the manual
!
before setting up or servicing this chassis.
Observe the following prerequisites when adding or replacing
hard disks.
Prerequisites:
–
–
–
Notice!
Insert the hard disks before initial system start.
See also:
–
–
4.1
Removing hard drive trays
The drives are mounted in drive carriers to simplify their
installation and removal from the chassis. These carriers also
help promote proper airflow for the drive bays.
To remove hard drive trays from the chassis:
1.
2.
3.
2014.07 | V1 | DOC
DIVAR IP only supports an even number of hard disks (2 or
4)
Bay 1 and bay 2 must be populated with hard disks
All hard disks of the unit must have the same capacity
Safety precautions, page 4
Installing a hard drive, page 17
Turn off the system.
Press the release button on the drive carrier. This extends
the drive carrier handle.
Use the handle to pull the drive carrier with the drive out of
the chassis.
DIVAR IP 2000
Bosch Sicherheitssysteme GmbH