Table of Contents
Advertisement
Bosch Recording Station Appliance
2.4.1
Control Panel Buttons
There are two push-buttons located on the front of the chassis. These are a reset button and a
power on/off button.
2.4.2
Control Panel LEDs
The control panel located on the front of the chassis has LEDs to provide you with critical
information related to different parts of the system. This section explains what each LED
indicates when illuminated and any action that may be required.
Bosch Security Systems
Reset
The reset button is used to restart the system.
Power on/off
The main power switch is used to apply or remove power from the power supply
to the system. Turning off system power with this button removes the main power
but keeps standby power supplied to the system. Therefore, you must unplug
system before servicing.
Power Failure
When this LED flashes, it indicates a power failure in the power supply.
Overheat/Fan Fail
When this LED flashes it indicates a fan failure. When continuously on (not
flashing) it indicates an overheat condition, which may be caused by cables
obstructing the airflow in the system or the ambient room temperature being too
warm. Check the routing of the cables and make sure all fans are present and
operating normally. You should also check to make sure that the chassis covers
are installed. Finally, verify that the heatsinks are installed properly. This LED will
remain flashing or on as long as the overheat condition exists.
NiC2
Indicates network activity on GLAN2 when flashing.
NIC1
Indicates network activity on GLAN1 when flashing.
HDD
Indicates IDE channel activity in the SAS/SATA drive, SCSI drive, and/or DVD-ROM
drive activity when flashing.
Hardware Installation Manual
System Overview | en
19
- | V1 | 2011.10
Advertisement
Table of Contents
