Part 3 Set Up - Lewmar AutoAnchor 560 Owner's Manual

PART 3 SET UP

3.1 USING THE AUTOANCHOR BUTTONS
Scroll: Menu/Numbers/Up/Down.
Mode/Select/Enter/Save.
On/Off/Escape or Back.
Hold together to access the Set up menu.
Hold for 2 seconds to disable the lock.
Hold for 2 seconds to return the AutoAnchor to the idle state.
3.2 SET UP MENU OVERVIEW
The AutoAnchor must be turned off to access the Set up menu.
Hold together to display the Set up menu.
Use to scroll through the menu.
General
Windlass
Diagnostics
diagnostics
Sensor
Up Solenoid
About
down Solenoid
Load Wires
Battery
V2
2.0
13
Up down
General Set Up
Language
Units
Windlass Set Up
Feet
docking distance
Meters
Total rode length
Fathoms
Rode
Key Beep
Chain only
Lock
Chain per turn
Factory defaults
Rope and chain
Preset
Chain per turn
Rope per turn
drum Winch
Inside diameter
Outside diameter
Sensor
Standard
Motor driven Reed
Gearbox ratio
Swap controls
3.3 GENERAL SET UP
To Access General Set Up
Turn the AutoAnchor Off.
Hold together to display the Set Up menu.
Select General.
To Exit General Set Up
Exit to the Set up menu or hold for 2 seconds to exit
to the start screen.
Set Language
Select Language.
Scroll to the preferred language.
Save.
Return to General Menu.
Set Units
Select units.
Scroll to meters, feet or fathoms.
Save.
Return to General Menu.
Set Key Beep
Scroll to key beep.
Save key beep on or off.
Set Lock - For safety we recommend the lock be left on.
Scroll to lock.
Save lock on or off.
3.4 FACTORy dEFAULTS
Resetting the Factory defaults clears all programmed
settings and logs.
To Reset Factory defaults:
Turn the AutoAnchor off.
Hold together to access the Set up menu.
Select General.
Select Factory defaults.
Select No/Yes.
yes - Apply the factory reset. The AutoAnchor will turn off.
Re-enter all your Settings.
No - Return to the General menu.
Hold the On/Off button down for 2 seconds to return the
AutoAnchor to the start screen.
14