Part 4 Operation - Lewmar AutoAnchor 560 Owner's Manual

3.10 dRUM WINCH SET UP
Access via the Windlass Set Up Menu. 3 settings are
required:
Total Rode Length.
Inside Diameter.
Outside Diameter with rode retrieved.
3.10.1 To Access Windlass Set up
Turn the AutoAnchor Off. Turn the AutoAnchor Off.
Hold together to access the Set up menu.
Scroll to Windlass.
Select Windlass. Select Windlass.
3.10.2 Set Total Rode Length
Add total length of chain plus total length of rope
Defaut = 60m or 196ft. Minimum setting = 10m (33ft)
Scroll to Total rode length.
Select Total rode length.
Increase or decrease the value in meters or feet.
Save and return to Windlass Set up.
3.10.3 To Enter the Inside and Outside diameter
Inside diameter -
rode fully deployed
Scroll to Rode.
Select Rode.
Scroll to Drum winch.
Select Drum winch.
Select Inside diameter.
Enter the measurement in mm or metric inches in mm or metric inches
(depending on the units selected).
Save and return to Drum winch set up.
Repeat for Outside Diameter.
Exit to Windlass Set up. Press twice to exit to the Set
Up menu or hold for 2 seconds to return to the start
up screen.
19
Setting:
Outside diameter -
rode fully retrieved
Rode
Inside Diameter:
Outside Diameter:

PART 4 OPERATION

AA560 BUTTONS
Sensor Pulse Indicator
& Windlass Direction
Status bar
Standard AA
Up down
Auto ON/OFF
Operation
Functions
Hold 2 sec
to Turn Off
Hold 2 sec
to Unlock
Note: Some operators prefer to swap the Up/Down buttons as follows:
Up = Out and Down = In. See the instructions on page 18.
4.1 INFORMATION dISPLAyEd dURING OPERATION
•
The length of rode deployed in feet, metres or fathoms.
•
The direction the anchor is moving.
•
The type of rode being deployed (chain or rope).
•
Windlass speed.
Settings and measurements are saved if the unit is turned off or the battery fails.
Counting continues if the windlass is operated by another control eg foot switches.
4.1.1 Lock
The AutoAnchor is fitted with a lock to help protect against unintentional windlass
operation.
Hold the Mode button for 2 seconds to unlock.
The lock automatically resets 5 minutes after the AutoAnchor was last operated or when
the AutoAnchor is turned off. You can also reset the lock by holding down the button
until the key is displayed in the top right corner.
In an emergency shut off the
power to the windlass using
the isolating/breaker switch.
u u
15
Locked Unlocked
20