Lewmar AutoAnchor 560 Owner's Manual page 14

Safety Override
Press any button on the AutoAnchor to stop the windlass during automatic release or
retrieval. In an emergency shut off the power to the windlass using the isolating/
breaker switch.
Enable Automatic Operation
A "rode to be released" value must be entered to use automatic operation.
To Set A Rode to be Released Value
Turn the AutoAnchor on.
Clear the safety lock.
Press the Mode button twice to enter Set auto.
Scroll up or down to change the value.
Save ready to deploy. Press twice to return to start screen.
To disable the automatic operation: Set the rode to be released
value to Off.
deploy the Anchor Using Automatic Operation
Turn the AutoAnchor on.
Clear the safety lock.
Press the Mode button to select Auto. The screen
displays the current length for Auto release.
If this setting is correct. Press and release the down button to
deploy the anchor.
To Change the setting:
Press the Mode button again to select Set auto.
Enter the value.
Save and return to Auto.
The windlass will stop and the AutoAnchor will beep when
the preset length of rode has been released. The screen
will display "Auto target reached".
Retrieve the Anchor Using Automatic Operation
Turn the AutoAnchor on.
Clear the safety lock.
Press the Mode button to Select Auto.
Press and release the Up button to retrieve the anchor.
The windlass will stop and the AutoAnchor will beep when the
docking distance is reached. The screen will display
Docking distance.
Press the Up button to complete retrieval of the anchor.
The AutoAnchor will beep during this process.
Ensure the anchor is fully docked and secured before moving the boat.
23
4.3 OTHER OPERATION SETTINGS
Press to access the menu when the AutoAnchor is turned on.
4.3.1 To Clear to Zero
The AutoAnchor must be turned on.
Press to access the Menu.
Select clear to zero.
Select No/Yes.
yes - return to start screen.
No - return to the menu, then press again
to return to the start screen.
4.3.2 To Check Logs
The AutoAnchor must be turned on.
Press to access the Menu.
Select Logs.
Return to the menu.
Exit and return to start screen.
Logs are cleared using the Factory Default Settings. See page 14.
Resetting the Factory defaults clears all logs and calibrations.
4.3.4 To Adjust Backlight
The AutoAnchor must be turned on. It is best to change this setting in low light.
Press to access the Menu.
Select Backlight.
Change the Backlighting level.
Save and return to the menu.
Exit and return to start screen.
4.3.5 To Reset Sensor
The AutoAnchor must be turned on.
Press to access the Menu.
Select Reset sensor.
Select No/Yes.
Save and return to the menu.
Exit and return to start screen.
Deploy the anchor to tune the sensor.
See page 21.
9
10742
112
Reset sensor
Reset sensor
Reset sensor
Clear to zero
Logs
Backlight
Reset sensor
24