IBM xSeries 346 Hardware Maintenance Manual And Troubleshooting Manual page 96

Note: See "System" on page 106 to determine which components a field service technician should replace.
Error code/symptom
035-XXX-S99
(Failed RAID test on PCI slot S. S =
number of failing PCI slot. Check the
system-error log and BMC log before
replacing a FRU.)
035-XXX-SNN
(Check system-error log and BMC log
before replacing a FRU. s = number of
failing PCI slot, nn = SCSI ID of failing fixed
disk.)
035-253-S99
(RAID adapter initialization failure)
075-XXX-000
(Failed power supply test)
089-XXX-001
(Failed microprocessor test)
089-XXX-002
(Failed optional microprocessor test)
166-198-000 System Management:
Aborted
(Unable to communicate with ASM. It may
be busy. Run the test again.)
166-201-001 System Management: Failed
(I2C bus error(s) See SERVPROC and
DIAGS entries in event log.)
166-201-002 System Management: Failed
(I2C bus error(s) See SERVPROC and
DIAGS entries in event log.)
166-201-003 System Management: Failed
(I2C bus error(s) See SERVPROC and
DIAGS entries in event log.)
86
xSeries 346 Types 8840 and 1880: Hardware Maintenance Manual and Troubleshooting Guide
FRU/action
1. Adapter
2. SCSI backplane
3. Cable
Hard disk drive with SCSI ID nn on RAID adapter in PCI slot s.
1. ServeRAID adapter in slot s is not configured properly. Obtain
the basic and extended configuration status, and see the
ServeRAID Hardware Maintenance Manual for more
information.
2. Cable.
3. SCSI backplane.
4. Adapter.
Power supply
1. VRM 1 for microprocessor 1
2. Microprocessor 1
1. VRM 2 for optional microprocessor 2
2. Optional microprocessor 2
1. Run the diagnostic test again.
2. Correct other error conditions and retry. These include other failed
system-management tests and items logged in the system-error log
of the optional Remote Supervisor Adapter.
3. Disconnect all server and option power cords from the server, wait
30 seconds, reconnect, and retry.
4. Remote Supervisor Adapter, if installed.
5. System board.
1. If installed, reseat the I2C cable between the Remote
Supervisor Adapter (in PCI slot 5/J5 on the PCI riser card) and
system management connector on the PCI riser card.
2. Reseat memory DIMMs.
3. Memory DIMMs.
4. System board.
1. Reseat I2C cable between the operator information panel and
the system board (J22).
2. Diagnostics panel.
3. System board.
1. Reseat cables between the system board and the power supply
or power cage assembly.
2. Power cage assembly.
3. System board.