IBM xSeries 346 Hardware Maintenance Manual And Troubleshooting Manual page 98

Note: See "System" on page 106 to determine which components a field service technician should replace.
Error code/symptom
202-XXX-001
(Failed system cache test)
202-XXX-002
(Failed system cache test)
206-XXX-000
(Failed diskette drive test)
215-XXX-000
(Failed IDE CD-ROM drive test)
217-198-XXX
(Could not establish drive parameters)
217-XXX-000
(Failed BIOS hard disk test)
Note: If RAID is configured, the hard disk
number refers to the RAID logical array.
217-XXX-001
(Failed BIOS hard disk test)
Note: If RAID is configured, the hard disk
number refers to the RAID logical array.
217-XXX-002
(Failed BIOS hard disk test)
Note: If RAID is configured, the hard disk
number refers to the RAID logical array.
217-XXX-003
(Failed BIOS hard disk test)
Note: If RAID is configured, the hard disk
number refers to the RAID logical array.
217-XXX-004
(Failed BIOS hard disk test)
Note: If RAID is configured, the hard disk
number refers to the RAID logical array.
217-XXX-005
(Failed BIOS hard disk test)
Note: If RAID is configured, the hard disk
number refers to the RAID logical array
264-XXX-0NN
(Failed tape drive test)
88
xSeries 346 Types 8840 and 1880: Hardware Maintenance Manual and Troubleshooting Guide
FRU/action
1. VRM 1
2. Microprocessor 1
1. VRM 2
2. Microprocessor 2
1. Rerun the test with a different diskette.
2. Cable.
3. Diskette drive.
4. System board.
1. Rerun the test with a different DVD-ROM drive.
2. DVD-ROM drive cables.
3. DVD-ROM drive.
4. System board.
1. Check cable and termination.
2. SCSI backplane.
3. Hard disk.
Hard disk 1
Hard disk 2
Hard disk 3
Hard disk 4
Hard disk 5
Hard disk 6
1. Tape cartridge, if user executed the Read/Write Tape Drive test
(failure code of XXX = 256)
2. SCSI or power cable connected to tape drive with SCSI ID nn
3. Tape drive with SCSI ID nn (refer to the Help and Service
Information appendix of the tape drive User Guide)
4. System board or SCSI controller (run SCSI controller diagnostic to
determine if the SCSI bus is functioning properly.)