IBM xSeries 346 Hardware Maintenance Manual And Troubleshooting Manual page 54

6. Install a VRM in the VRM connector (J72).
7. Install the microprocessor:
44
xSeries 346 Types 8840 and 1880: Hardware Maintenance Manual and Troubleshooting Guide
a. Touch the static-protective package containing the microprocessor to any
unpainted metal surface on the server. Then, remove the microprocessor
from the package.
b. Remove the protective cover, tape, or label from the surface of the
microprocessor socket, if present.
Attention: You must ensure that the locking lever on the microprocessor
socket is in the fully open position before you insert the microprocessor in
the socket. Failure to do so might result in permanent damage to the
microprocessor, microprocessor socket, and system board.
c. Rotate the locking lever on the microprocessor socket from its closed and
locked position until it stops or clicks in the fully open position
(approximately 135° angle).
Attention:
v Do not use excessive force when pressing the microprocessor into the
socket.
Make sure that the microprocessor is oriented and aligned with pin
v
number 1 in the socket before you try to close the lever.
d. Center the microprocessor over the microprocessor socket. Align the triangle
on the corner of the microprocessor with the triangle on the corner of the
Lever closed
Lever
fully
open
Lever closed
Lever
fully
open