IBM xSeries 346 Hardware Maintenance Manual And Troubleshooting Manual page 88

Types 8840 and 1880
Hide thumbs Also See for xSeries 346:
Table of Contents

Advertisement

Note: See "System" on page 106 to determine which components a field service technician should replace.
Error code/symptom
161
(Real time clock battery error)
162
(Device configuration error)
Note: Be sure to load the default settings
and any additional desired settings; then,
save the configuration.
163
(Real-time clock error)
164
(Memory configuration changed.)
175
(Hardware error)
176
(Computer cover or cable cover was
removed without a key being used)
177, 178
(Security hardware error)
184
(Power-on password damaged)
185
(Drive startup sequence information
corrupted)
186
(Security hardware control logic failed)
187
(VPD serial number not set.)
188
(Bad EEPROM CRC #2)
189
(An attempt was made to access the
server with invalid passwords)
201
(Memory test error.) If the server does not
have the latest level of BIOS installed,
update the BIOS to the latest level and
run the diagnostic program again.
229
(Cache error)
78
xSeries 346 Types 8840 and 1880: Hardware Maintenance Manual and Troubleshooting Guide
FRU/action
1. Run the Configuration/Setup Utility program.
2. Battery.
3. System board.
1. Run the Configuration/Setup Utility program.
2. Battery.
3. Failing device.
4. System board.
1. Run the Configuration/Setup Utility program.
2. Battery.
3. System board.
1. Run the Configuration/Setup Utility program.
2. DIMM.
3. System board.
System board
1. Run the Configuration/Setup Utility program.
2. System board.
1. Run the Configuration/Setup Utility program.
2. System board.
1. Run the Configuration/Setup Utility program.
2. System board.
1. Run the Configuration/Setup Utility program.
2. System board.
1. Run the Configuration/Setup Utility program.
2. System board.
1. Set serial number in the Configuration/Setup Utility program.
2. System board.
1. Run the Configuration/Setup Utility program.
2. System board.
Run the Configuration/Setup Utility program, and type the
administrator password.
1. DIMM
2. System board
1. Microprocessor
2. Optional microprocessor (if installed)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents