IBM xSeries 346 Hardware Maintenance Manual And Troubleshooting Manual page 40

v If you are installing an optional ServeRAID-7k, review the following information:
The following illustrations show the location of the PCI and PCI-X adapter
expansion slots on the PCI low-profile card and PCI riser card.
PCI low-profile card
30
xSeries 346 Types 8840 and 1880: Hardware Maintenance Manual and Troubleshooting Guide
– No rerouting of the internal SCSI cable is required if you are installing the
ServeRAID-7k.
– The ServeRAID-7k can be installed only in a dedicated slot on the system
board.
Attention: To avoid breaking the retaining clips or damaging the connectors,
handle the clips gently.
The following illustration shows how to install the ServeRAID-7k.
Note: If there is a gap between the card and the retaining clips, the card has not
been properly installed. In this case, open the retaining clips and remove the
card; then, reinsert the card.
Connector
PCI-X slot 1 64-bit
3.3V 100 MHz (PCI1)
PCI-X slot 2 64-bit
3.3V 100 MHz (PCI2)
ServerRAID-7k