2.7 Adjustment of Scanning Section
2.7.1 Adjustment of the carriages
(1) Installing the carriage wire
Install a new carriage wire as in the following figure when it is replaced.
[Front side]
Wire winding pulley
Idler pulley
[Rear side]
(2) Adjustment of the carriage wires
Adjustment is not necessary since a certain tension is applied to the carriage wires by the tension
springs.
Note: Make sure that the tension applied to the wire is normal.
DP4500/3500 ADJUSTMENT
Carriage wire (black)
Bracket for Carriage-1
Hook
Spring
Idler pulley
Carriage-2
Carriage wire (silver)
Bracket for Carriage-1
Idler pulley
Carriage-2
Hook
Spring
Wire winding pulley
Idler pulley
2 - 30
December 2000 © TOSHIBA TEC