Toshiba DP4500 Service Handbook page 44

[Procedure to input the adjustment values]
In accordance with the following procedure, adjust each adjustment item so that the measured
values obtained from the test copy satisfy the specification. Single-side test copying can be per-
formed (in the normal copy modes) by pressing the [FAX] key immediately after entering the adjust-
ment mode (05).
<Keys used in operation>
[0] [5]
[POWER]
1
[Digital keys]: Enter a code.
[START]
[Digital keys]: Enter an adjust-
ment value.
[C/S] Corrects the value
Value "ZZZ" is newly
[SET]
stored in BC-RAM
or
instead of "YYY".
[INTERRUPT]
[FAX]: Test copy
If the copied image does
not satisfy the specifica-
tions, return to
perform the adjustment
again.
[0] [9]: To exit the adjustment
mode
December 2000 © TOSHIBA TEC
<Display>
100%
TEST MODE
XXX
100%
TEST MODE
YYY
Current adjustment value
100%
TEST MODE
100%
WAIT WARMING UP
100%
, and
COPYING
2 - 5
Varies depending on the code "xxx"
entered with the digital keys.
A3
A
Code No.
A3
ZZZ
A3
A
A3
A
A3
A
DP4500/3500 ADJUSTMENT
Adjustment value
newly entered (YYY
is default display).