Adjustment Of Angle Of The Printed Image - Toshiba DP4500 Service Handbook

2.8 Adjustment of Angle of the Printed Image

(1) Print out a grid pattern in the test print mode (04-142). Measure the deviation A (see the figure below)
against the distance of 240mm in the feeding direction on the grid pattern.
(2) Remove the rear side upper cover.
(3) Look at the scale on the frame and write down the position of the stay before making an adjustment.
(4) Loosen the adjustment screw and slide the stay as much as the deviation A on the printed grid pattern
in the direction as described below to adjust the deviation of the laser optical unit.
ex.) If the grid line is slanted by 1mm to the rear side, slide the stay 1mm downward.
(a) The grid line is slanted to the rear
side against the feeding direction.
Slide the stay downward.
Stay
Note: Print out an image and check if it is positioned properly. Adjust the printer section following "2.3
Dimentional Adjustment of Copied Image" if necessary.
December 2000 © TOSHIBA TEC
A
(b) The grid line is slanted to the front
Scale
(space between
each mark: 1mm)
2 - 37
side against the feeding direction.
Slide the stay upward.
Adjustment screw
Stay
DP4500/3500 ADJUSTMENT
A