Customer Set Relocation; Data Security - Samsung OfficeServ 7030 General Description Manual

Split
A keyset user can "split" a conference into separate outside calls, then speak with each caller privately. Then
the individual calls can be conferenced again in any combination. NOTE: This feature requires individual trunk
buttons and auto-hold must be enabled.
CONFERENCE GROUP
Users that have a IP large screen keyset or OfficeServ Softphone may have 1-5 conference groups pro-
grammed. Each conference group can have up to 5 parties assigned. They can be extensions in the system or
telephone numbers of people outside the system. Press the Conference Group button to call all members of
the group at the same time. Status indications appear in the display. Press the corresponding softkey to drop
or call parties as desired (maximum 100 users).

CUSTOMER SET RELOCATION

Customer Set Relocation allows the customer to exchange or swap similar stations in the OfficeServ 7030
without wiring changes. All individual station assignments such as trunk ring, station group, station COS, sta-
tion speed dial, button appearances, call forwarding, etc. will follow the Customer Set Relocation program.

DATA SECURITY

Single line extensions used with modems and facsimile machines can be programmed so that they will not
receive any system-generated tones that would disrupt data transmissions. In addition, these devices receive
DCS C.O. ringing pattern instead of intercom ring pattern. Devices connected to an SLI card receive a discon-
nect signal upon termination.
DATABASE PRINTOUT
A copy of the customer database can be obtained by using the Web Management program. This information
can be directed to a printer or the PC screen and may be done either on-site or remotely. A complete data-
base or specific data blocks may be obtained.
DAYLIGHT SAVING TIME-AUTOMATIC
The system has a table that can be programmed with the daylight savings change dates for up to 10 years.
At 2:00 am on these dates the system will automatically adjust the system clock to match daylight savings
time. If no dates are programmed the clock will not change.
DIRECT IN LINES
Outside lines may be programmed to bypass the operator(s) and ring directly at any station or group of sta-
tions.
DIRECT INWARD SYSTEM ACCESS (DISA)
Users can call in on specific DISA lines at any time, input a security code and receive system dial tone. Users
can now place internal calls or if permitted, calls using C.O. lines. The caller must have a tone dial phone and
know his/her DISA security code if DISA security codes/passcodes are turned on. DISA lines can be used as
both way lines or incoming only and may be allowed or disallowed for any of the 6 ring plan time periods.
The C.O. lines used for DISA must have disconnect supervision. The requirement to put in a DISA security code
can be disabled if desired.
DIRECT TRUNK SELECTION
Each station can be allowed access to or denied access from a trunk or trunk group by access code when LCR
is activated. When restricted, the station user must use a trunk key or a route key.
4.15