JRC JMA-9832-SA Instruction Manual page 69

!9
: CPA setting
Position the arrow cursor on the value area and click the trackball section left button, then the ten-
key pad can be used to enter a value. After entering the value, press the
@0
: Vector length setting
Position the arrow cursor on the value area and click the trackball section left button, then the ten-
key pad can be used to enter a value. After entering the value, press the
length.
@1
: DRIFT setting
Position the arrow cursor on the value area and click the trackball section left button, then the ten-
key pad can be used to enter a value. After entering the value, press the
DRIFT.
Attention:
This function is available only when CORRECTION in the SET/DRIFT Menu is ON.
Also, CORRECTION can be turned ON only when the speed unit is set to MANUAL or LOG (1-AXIS).
@2 :
SET setting
Position the arrow cursor on the value area and click the trackball section left button, then the ten-
key pad can be used to enter a value. After entering the value, press the
Attention:
This function is available only when CORRECTION in the SET/DRIFT Menu is ON.
Also, CORRECTION can be turned ON only when the speed unit is set to MANUAL or LOG (1-AXIS).
@3
: Speed unit setting
Setting the speed unit.
/
MANUAL
Attention:
An alarm is activated if the selected speed unit is not connected to the radar.
/
LOG 2AXW
1-axis log 2-axis over water
2 – 10
2.2 FUNCTION OF SOFTWARE BUTTONS
/
2AXG
2-axis over ground
..
ENT
to set the CPA.
ENT
to set the vector
ENT
to set the
ENT
to set the SET.
2