JRC JMA-9832-SA Instruction Manual page 165

[ 5 5 ] Setup and Display of Geodetic System
In making up any navigational information, it is necessary to set up the geodetic system used by
the connected navigation equipment. When any saved navigational information is loaded, the
geodetic system used when the navigational information was saved will also be displayed. Then,
check that the geodetic system on display is the same as that for the connected navigation
equipment. If both geodetic systems are different, the positions of the navigational information on
radar display may be deviated. Therefore, it is important to set the same geodetic system as the
navigation equipment.
MENU
Exit 1 Press
The Main Menu will appear.
2 Press
The Sub1 Menu will appear.
3 Press
The NAV/MAP INFO Menu will appear.
4 Press
4.GEODETIC
5 Select the number of geodetic system using any of
0
to
When the number of geodetic system is entered, its name is changed.
ENT
6 Press
The selected geodetic system will be set up.
Exit 1 Press
The Sub1 Menu will reappear.
2 Press
The Sub1 Menu will be closed.
.
8
.
3
.
4
.
will be selected.
9
. (See Table of Geodetic Systems)
.
0
.
0
.
3 – 94
3.4 BASIC OPERATIONS
S U B 1 M E N U
NAV/MAP INFO
1.WPT Geodetic system No. input
OFF ON
2. NAV DISP
3. NAV/MAP
4.GEODETIC
WGS-84
Geodetic system name display
area: The display changes
according to the geodetic
system No. in the right input
area.
0. E X I T
+ -
and
. ..
3
0
or