JRC JMA-9832-SA Instruction Manual page 107

y
Position the arrow cursor over the desired selection and selected it, then press the trackball section
left button.
u
The pull-down menu will be closed and the setting will be determined.
[3 3 ] Value Input Type of Setting Changes
This method can be used in most of boxes where a numeric value is to be entered.
q 0.0-100.0kts
When the value is set as shown in the figure
The minimum and maximum (min-max) are displayed on the left side and the unit is also displayed
if present.
w 0.0-100.0kts
To increase the value, move the arrow cursor to the position in the figure
the trackball.
e 0.0-100.0kts
With the arrow cursor on the position in the figure
r 0.0-100.0kts
The value will be increase in the minimum step.
t
To increase the value continuously:
Hold down the trackball section left button in the figure
y
To decrease the value:
Move the arrow cursor to the downward triangle in the figure
The following procedures are the same as for increasing.
3.4 BASIC OPERATIONS
q
:
w
, click the trackball section left button once.
e
.
w
.
3 – 36
. ..
w
(upward triangle) with
3